by Microtek Industries | Aug 10, 2021 | Industrial & Power Electronics Lab
The trainer kit helps to studies: Voltage Commuted Step Down Thyristorised Chopper.Current Commuted Step Down Thyristorised Chopper. The trainer consists of the following : High Voltage Source : 80 V [Fixed].Thyristor – Trigger Control Circuit.Chopper Circuit.Digital...
by Microtek Industries | Aug 10, 2021 | Industrial & Power Electronics Lab
The equipment helps to study the load voltage & current waveforms for different values of firing angle a. The setup consists of : Triac based Control circuitDigital AC Voltmeter : 0 – 500 V AC, 3 ½ digit Display.Digital AC Ammeter : 0 – 5 Amp AC, 3 ½ digit...
by Microtek Industries | Aug 10, 2021 | Industrial & Power Electronics Lab
The equipment helps to study the waveforms & plot of armature volt ( D.C ) vs Speed & its control of a D.C. shunt wound motor using SCR. The setup consists of : ¼ H.P. D.C. Shunt Wound Motor.Thyristor Drive Circuit.Digital Voltmeter : 0 – 500 V DC, 3 ½...
by Microtek Industries | Aug 10, 2021 | Industrial & Power Electronics Lab
The single board trainer with in built I.C regulated power supply helps to study the Monostable, Astable & Bistable Miltivibrator, Time delay & Sequental timer using 555 IC. Additional Accessory Required : Oscilloscope
by Microtek Industries | Aug 10, 2021 | Industrial & Power Electronics Lab
The single board trainer helps to study the output voltage and current waveforms, at different values of firing angle, for resistive and inductive loads for the following single phase rectifier configurations. To study the working of a Bridge rectifier.To understand...
